Quote:
|
Originally Posted by kizzap
i have found a block design that might be possible to use here. does anyone have any Ideas or comments on the block design? |
Now that is an interesting design. Looks like a zalman heatsink type design. I wouldnt do it in that particular way though, You would be much better off if you drilled many tiny holes for the water to run through than just 3 large ones. I think Cathar did a cross drilled waterblock with many many small holes running parallel through the block. Really, you would need 2-3 plates for the barbs, then a couple of open ones, then the middle would have the many holes, then a couple of hollow ones to allow for the water to make the turn, then a solid one to close it off.