Pro/Forums - View Single Post - Need someone to construct a Chiller Block circulating -80°C FLUID!!!

placebo · 05-18-2004, 05:08 PM

Hello together ...

I just found this website and forum while browsing through the internet ... well, I actually found the article about (#Rotor Waterblock Review).

So I signed up and this is my first post ...

My current project involves a liquid chiller which works down until approx. -80°C.

I do have the heat transfer fluids, special pumps, stainless steel hosing, etc. ... However ... at the moment I am starting to get concerned about heat-exchanger "fluid"-block.

Actually this would be more than just the block design .... What I am looking for would be a unit, similar to the Prometeia "cooling-head" (Just instead of having the heat evaporater block, I now need a heat-exchanger for the chilled liquid to circulate through).
The design should consist of the following:

1.) Fluid-Block
2.) Connections for stainless steel hoses
3.) Insulation
4.) Case with mounting holes

Ideally I am looking for someone who would be able to construct the whole "unit" and have it shipped to me. For a "complete" design and construction I would be willing to pay around $200 - $300 (hope this sounds realistic!)

05-18-2004, 05:08 PM	#1
placebo Cooling Neophyte Join Date: May 2004 Location: europe Posts: 3	Need someone to construct a Chiller Block circulating -80°C FLUID!!! Hello together ... I just found this website and forum while browsing through the internet ... well, I actually found the article about (#Rotor Waterblock Review). So I signed up and this is my first post ... My current project involves a liquid chiller which works down until approx. -80°C. I do have the heat transfer fluids, special pumps, stainless steel hosing, etc. ... However ... at the moment I am starting to get concerned about heat-exchanger "fluid"-block. Actually this would be more than just the block design .... What I am looking for would be a unit, similar to the Prometeia "cooling-head" (Just instead of having the heat evaporater block, I now need a heat-exchanger for the chilled liquid to circulate through). The design should consist of the following: 1.) Fluid-Block 2.) Connections for stainless steel hoses 3.) Insulation 4.) Case with mounting holes Ideally I am looking for someone who would be able to construct the whole "unit" and have it shipped to me. For a "complete" design and construction I would be willing to pay around $200 - $300 (hope this sounds realistic!)