Pro/Forums - View Single Post

shyet · 05-19-2004, 01:53 PM

I was running Prime95 to test the stability of my new 2400+ Mobile. When I looked at MBM5 it showed my CPU temp at 59C!! One minute later, my computer shuts off (I have it set to shut off at 60C). This is at 1.45Volts!!!! Prime95 was running for about 10 to 15 minutes.

I thought maybe I didn't mount the waterblock correctly until I felt it. The waterblock was burning hot! With my 2400+(desktop) at 2.03V, the waterblock would feel a little warm.

Was my pump not (MCP600) not working? I couldn't tell if the pump was on or not because I can't hear the pump with my side panel closed. But when I felt the pump, it felt cold. It usually gets warm.

Anyway, when I turned my PC back on, everything seems fine. CPU tems is 36C Load.

What happened here? Did the pump not turn on? Why wouldn't it? Could it be my power supply? I hope it's the not the pump.

05-19-2004, 01:53 PM	#1
shyet Cooling Neophyte Join Date: Apr 2004 Location: Florida Posts: 24	Pump failing?!?!? MCP600 I was running Prime95 to test the stability of my new 2400+ Mobile. When I looked at MBM5 it showed my CPU temp at 59C!! One minute later, my computer shuts off (I have it set to shut off at 60C). This is at 1.45Volts!!!! Prime95 was running for about 10 to 15 minutes. I thought maybe I didn't mount the waterblock correctly until I felt it. The waterblock was burning hot! With my 2400+(desktop) at 2.03V, the waterblock would feel a little warm. Was my pump not (MCP600) not working? I couldn't tell if the pump was on or not because I can't hear the pump with my side panel closed. But when I felt the pump, it felt cold. It usually gets warm. Anyway, when I turned my PC back on, everything seems fine. CPU tems is 36C Load. What happened here? Did the pump not turn on? Why wouldn't it? Could it be my power supply? I hope it's the not the pump. Last edited by shyet; 05-19-2004 at 10:09 PM.