I've been able to do mine. I use Elmer's Probond glue, silicone and a custom acrylic reservoir, two bolts, two nuts and a piece of acrylic behind it. The bolts/nuts/acrylic are probably redundant, but I don't like my stuff coming apart. Basically I cut a hole in the acrylic the right size for the pump, covered the front of the pump with the glue (expanding polyeurethane glue, super hold) pushed it into the hole, duct taped it on, and put silicone around the hole at the front. I then waited for it to dry, took off the duct tape, and attached the front of my reservoir to the rest.
|