Pro/Forums - View Single Post

Pricey · 05-23-2004, 11:04 PM

Well, I think that sounds pretty good.

I am boarding at a college and I think I may be able to have access to a lathe and miller, they only have 2mm bits, so I may have to go out and get some...

I will try the Easy & Cheap design.

A : Slaterspeed, How wide are your channels (if you mind saying so)?
B : What are the bits used for cutting through Copper, and how much are they approximately? Yes I know I should go out and find myself but being a boarder its a tad hard...

Thanks,
Pricey

05-23-2004, 11:04 PM	#10
Pricey Cooling Neophyte Join Date: Apr 2003 Location: Australia Posts: 12	Well, I think that sounds pretty good. I am boarding at a college and I think I may be able to have access to a lathe and miller, they only have 2mm bits, so I may have to go out and get some... I will try the Easy & Cheap design. A : Slaterspeed, How wide are your channels (if you mind saying so)? B : What are the bits used for cutting through Copper, and how much are they approximately? Yes I know I should go out and find myself but being a boarder its a tad hard... Thanks, Pricey