Quote:
|
Originally Posted by Jabo
Similarly producing variations on the same theme based on the same old design is equally useless  I'd rather see no action for a while and then something worthwhile resulting than constsnt stream of tweaked pin/fin designes! |
Who are you refering to? Me or Swiftech? Either way your incorrrect. In any event if the numbers continue to get lower there is certainly nothing usless about it. What is useless is taking days to make a calculation on cold plate thickness when you can mill every size of thickness from 5/8" to 1 mm in less than an hour and test each one. Once your special calculations are complete you STILL have to test each size to make sure you theory is correct. Why waste time calculating..... it is a cold plate for christ sake. Flat peice of metal!
And where is all YOUR work posted on the subject? Where is your blocks, your plates, ect... Who are you to judge what is usless?