Quote:
|
Originally Posted by kronchev
ill give you 30 dollah to make me one  |
I would do it if I had the time. My mill is setup at my grandparents shop 130miles (one-way) from here. I live in an apartment in the city. Costs me $30 just in gas to get up there and back.
I also travel for a living. Headed out of town for a couple weeks on Tues. Sigh....
Are you in the USA?
Here is a pic of the drawing for the Lumpy Channel 2. Minus the top peice. The only difference is there is 2 less holes drilled on each channel. I think that will make it a little less restrictive and shouldn't hurn performance as those holes are past the point were the heat from the CPU will spread.