UPDATE 07/06/04
New parts arrived today, the AS5, the Tygon (0.5 inch, all 8 feet baby), and the rubber edging.
Step 6
I finished the cutting of the shuttle, both ends are done and the hole in the middle for the wires/tubing etc.
Step 7
Cut out the rubber edging, probably the most time consuming bit yet getting it all to fit. I did both ends, and then the rubber square in the middle.
The ends were done to make it slightly less ugly (it's the first time I've ever used anything to cut bigger than a junior hacksaw, when I was very ickle), but the square in the middle was imperative so I wouldn't scratch the tubing.
I then placed the rads, shrouds and fans in, thought I didn't screw them down, and placed the top over.
I will get a grill for the rear, don't worry.
Step 8
Threaded all the power wires through and set it up on the top, with the lid on. Time to get an idea how this baby will run.
N.B. The shroud at the front will be raised up so you won't have the ugly as hell empty slot above it that you can see in the pics below:
Side view:
In the dark:
3/4 view
Another 3/4 view
Hope you like, more parts will arrive tomorrow, so there may be an update then.