Quote:
|
Originally Posted by bigben2k
The only part that concerns me here is this new die simulator of yours: what made you go with 1000 mm^2 contact area? I mean, you know that the IHS spreads heat, but it doesn't spread it out that far, where your simulator does. That effectively decreases the heat density, and will cause performance variations based on the water block design i.e. if I run the same test on the same series of blocks, I'm going to get different results, and maybe even a different order.
|
Hey Ben,
Sounds like we need to re-open the die size discussion and kick it around some more...
I'm open to suggestions and justification for going with something other than 1,000 mm2. Let's take that discussion back over
here instead of in this thread.