Quote:
|
Originally Posted by Fragger56
thanks again bigben, ive now found several places that should have the heaters in indiana 
mind if i ask how these things are usually attached? just drill holes that are as close in size to teh diameter of teh heater and slide it in? do i need to use TIM on them? and any recommendations on thermal probes/thermocouple's and reader thingamijigs for them?
also could someone tell me where teh best places to put thermocouples would be? ive read through bill adams testing site thingy but i still dont quite get it and i am definately not gonna drill holes in my RBX or the Cascade taht wil be lent to me for testing from a friend. |
Kewl, maybe you can share some of them with us!
Yeah, drill a hole in the copper mass, use a TIM, that's it.
Some people use thermocouples, a few prefer RTDs (Bill and I?).
I had a thread going about placement of the cartridges, which turned out to be nonsense, but in there is a bit about placement of probes.
Here it is!