Quote:
|
Originally Posted by Cathar
.....that certainly does not seem to fit well with results seen for JoeC's 130mm^2 die, or even really match up that well if we extrapolate to BillA's test-bed.
...
|
Or is JoeC's 140 mm^2 ?
To quote Bill, "JoeC told me yesterday the die area was 140mm²
sorry Les, should have posted" -
link
Would also like to know the offset (from TIM interface) of the die temperature sensor.
Bill's was ~ 2mm, but has this been reduced by lapping?
Awaiting more info on die sizes before spending too much time on sums.