Quote:
Originally posted by SYX:
lol theres no condinsation unless u go to sub zero temps, which is done commonly with something like peltier, and because cpu heats up a bit after pc was turned on sudden change of temps can generate some condensation... this will happen no matter how moist air is, even if a little bit.. what u need is a sensor/control type device that will keep peltier off untill cpu temps go high enough.
|
WRONG.. and this is one of the biggest misconceptions!!!
You CAN get condensation ANY time you drop just below ambient depending on where the dew point lies. In a 100% humidity environment, if you drop a couple degrees below ambient you will get some condensation to form.
You will get condensation in the form of ICE if you drop below 0C. Really anytime you are doing something to lower the temp below the ambient temp you should institute some sealant action.
I am going to go a closer in depth write up of sealing and stuff then I did in the Mini. In the mini though, the way I insulated it was done to allow the machine to run continuously without the worry of ice/water forming. I coulda gotten away with less, but I didn't want to risk it.
From what I have seen, Neoprene around the socket and in the socket is the way to go then seal it all with the conformal silicone. DO NOT USE RTV. I will also be working on a "Why not to use RTV", and viable replacements geek gear article.
------------------
C-ya
Joe - Owner/Editor
www.ProCooling.com
Where the Completely Addicted Come to Cool Off
Somebody set up us the bomb.