Pro/Forums - View Single Post

#Rotor · 06-28-2004, 03:47 PM

you need to spread the cooling to more than just the die size in the middle of the block...
try to stay away from a mazy channeled design...... A grid design give smoother cooling over a large area...

make sure you have ample clamping provided by the block and coldplate.... at least 4 bolts evenly spaced around the TEC..... but more is always better...

keep in mind that you would want to do some insulation, so pay attention to the retention mechanism.... keep it simple and effective, that way making it much easier to insulate

06-28-2004, 03:47 PM	#2
#Rotor Cooling Savant Join Date: Feb 2002 Location: Dione, sector 4s1256 Posts: 852	you need to spread the cooling to more than just the die size in the middle of the block... try to stay away from a mazy channeled design...... A grid design give smoother cooling over a large area... make sure you have ample clamping provided by the block and coldplate.... at least 4 bolts evenly spaced around the TEC..... but more is always better... keep in mind that you would want to do some insulation, so pay attention to the retention mechanism.... keep it simple and effective, that way making it much easier to insulate __________________ There is no Spoon....