what about acrilic (bad spelling i know) or plexiglass??
would those be easy to use?
if i remember to cut those its easier to use a razorblade to sort of precut it where you can just hammer the piece off and it will break where you razorbladed it...
(i remember my dad trying to use his circular saw on one of those and it basically shattered....)
the other questions still remain though, is a enhiem 1250 decent enough for that system? and since its going to be clear, are the HWlabs rads decent? (although expensive)
and one more i was thinking about, should the res go in the external case or the actual case, i only ask because depending on where i put the external case, it may not be at the highest point in the system..
|