Quote:
|
Originally Posted by Cathar
(sigh)
...outperforms any other "US" block given whatever pump you care to throw at them, and for our "wunder-kuhler" itself does not achieve more than a 0.01C/W gain for a 100mm^2 sized die when couple with, say, a Danner Mag 3, effectively making it pointless for any heat load less than around 200W to ever consider sticking a stronger pump than an Eheim 1046 on it.
I sure you knew the point I was getting at, but are probably just determined to make me jump through logical hoops for amusement factor I guess.
|
I knew what you meant, was being a little bit facetious with the above post. Sorry about that.
This is my problem of the day actually. The "crossover" point being the major uncertainty for me but I have been playing around a bit and I think that there is a way to maximise this. My next block will I hope demonstrate this, when other commitments allow it. In my universe one thing is for sure, a flat curved block outperforming a "US" block up to 7-8lpm can not be done with a thin baseplate.