Pro/Forums - View Single Post

Cathar · 07-03-2004, 11:19 PM

I wonder if any of the manufacturers were contacted prior to publishing?

No way the Swiftech kit performs as badly as indicated if setup properly. There would've had to have been something seriously wrong. I personally suspect that they forgot to open the third tap on the fill and bleed system after filling, and the water flow was probably only trickling through at a rate of 0.1LPM (or whatever), which is what would've been happening for it to perform so badly.

No mention of ambient temperature control either. Who knows what was really going on?

07-03-2004, 11:19 PM	#3
Cathar Thermophile Join Date: Sep 2002 Location: Melbourne, Australia Posts: 2,538	I wonder if any of the manufacturers were contacted prior to publishing? No way the Swiftech kit performs as badly as indicated if setup properly. There would've had to have been something seriously wrong. I personally suspect that they forgot to open the third tap on the fill and bleed system after filling, and the water flow was probably only trickling through at a rate of 0.1LPM (or whatever), which is what would've been happening for it to perform so badly. No mention of ambient temperature control either. Who knows what was really going on? Last edited by Cathar; 07-03-2004 at 11:28 PM.