Quote:
|
Originally Posted by Silent Bob
I just can´t stop thinking that if you were german, you would produce
|
For high ultra-low-flow/pressure performance, true micro-channels is where it's at.
What's the cheapest/easiest way to make a C101 copper basic micro-channel waterblock with 0.1mm wide channels, rounded on the bottoms of the channels, with 0.15mm wide x 0.8mm tall channel walls, with a 2mm thick base-plate, and the channelled area being 30x30mm in size? Build that, and there's your answer.
Just filter the sucker for all you're worth.
Quote:
|
Originally Posted by Silent Bob
except for Hydrocool´s Hydro-Stream, which is an Australian micro-channel wb
|
Funnily enough, the HydroStream's engineer is a German guy, who just happens to be living here in Australia. The Hydro-Stream is also a fairly basic side-to-side micro-channel implementation from looking at pictures on their website, but not as finely channeled as I'm talking about above, and the channels are soldered on, rather than one-piece.