View Single Post
Unread 07-09-2004, 07:49 PM   #48
Cathar
Thermophile
 
Cathar's Avatar
 
Join Date: Sep 2002
Location: Melbourne, Australia
Posts: 2,538
Default

Quote:
Originally Posted by unregistered
- just how much is a small form factor worth ? (will fit in a drive bay with a 50,000 MTBF)
See, you say that, and I immediately think a small flat box, much like a half height disk-drive.

Got two barbs at the back, a molex connector. Using a turbine style impeller mechanism as this best suits the low-flat model, with a mag-drive using modified hard-disk drive motor technology spinning a magnetic armature, with the impeller sealed and effectively surrounding the motor magnet armature (ie. like the Davies-Craig EBP does it, which is like the MCP600 but reversed). Or alternately, a drive mechanism similar to the Laing D4, except with a turbine impeller instead of a centrifugal impeller attached.

Would make for an excellent high-pressure, low-power, and efficient pumping mechanism. Something that would sell like hot-cakes in the water-cooling market if enough economy of scale were brought to bear on the problem.

Could even make the whole thing serviceable, with an O-ring seal lid allowing access to the impeller assembly.
Cathar is offline   Reply With Quote