Quote:
|
Originally Posted by caxis0
Well, I may drill holes, or I may not depending on how I feel considering the fan filter conceals it anyway. If using 4 instead of 8 screws makes me semi ghetto, then go on and toss me a 40.
I dunno, you be the judge if I'm ghetto, check my project log. It's a project in its infancy, but should give you an idea of my work.
Also, Red Phoenix, this thread may help you understand what issues you will run into mounting the BIM2 in the front.
Bruce |
That's just my point of view, no offense intended...
I recommend not to use the fan filter. Fan filters are bad for air flow, especially when used on a rad (I removed mine too).
Keep your room clean of dust as much as possible, put the case on a desk (not on the floor) and clean the rad/fans regularly.
I would construct a small rectangular shroud that adapts the two front fan holes to the exact dimensions of the BIM2 (and even transform the two round fan holes to one rectangular hole), then attach the BIM2, and eventually add another shroud between BIM2 and the two (pulling) 80mm fans.
CD
