Quote:
|
Originally Posted by caxis0
I need to construct a 2x80mm shroud. I want to use sheet metal or something similar and aluminum tape. What should I know before I attempt to do this? What should I use to cut the stuff? Is there a thickness that is readily available--I'm not sure exactly what I should ask for/where to find it.
Thanks.
Bruce
|
I used 1mm thick (about 1/25") anodized aluminium sheet.
It's very easy to cut with a fretsaw.
Bendings are easier if you precut:
After bending I glued the joints with Rectafix glue:
Your shroud is different but I hope you got the picture...
CD
