[arcsylver]

Hmmmm, Seems I have hit a snag

System is leak free. Overclocks effortlessly to 3.01.Ghz (FSB 215) in the Bios and shows a system temp in the PC Health Status of 35C.

Unfortunately after the system POST it begins initialising the drives then displays an infinite loop of 1's and 0's.


Anyone have any idea what this means?

Have I completely fried my setup or do I have a dud mobo?

As for the dimensions of the Radiator.

It is approximately 24 inches wide by about 22 inches tall on the actual finned area with brass tanks on the top and bottom that are approximately 4 inches.

The Rad is a good 2 and a half to three inches thick.

I took off the stock 2 inch tubes and covered the hole with some copper plate made by flattening a couple of pieces of copper piping. Then I installed three 1/2" ID barbs, two at the top and one at the bottom.