Pro/Forums - View Single Post - A Question/Challenge about my upcoming project,

cougem · 07-19-2004, 01:14 PM

I'm about to move onto my second project, and I'm considering using a V2000 as a base unit, shown here:

Another blokes used one here,

And I've currently also got a water cooling system I have to fit in. Thing is I've got 2 single heatercores, from soulsend, shown here:

The shroud itself is 6"x6"x2" and the heatercore 7 1/2”x6”x 2”. They seem to be approximately 16cm x 18cm x 10cm, but that's a guess from very rough measuring.

Now, the question is, how do I fit these babies in....

I was thinking of say moving the PSU to the up a bit, so it's where the radiator is on the above guy's setup, and then having the heatercore on its side below, so it blows right to left, but I'm not sure that'll work.

Anyone have any ideas? I'm stumped.

07-19-2004, 01:14 PM	#1
cougem Cooling Savant Join Date: May 2004 Location: Cambridge Uni Posts: 176	A Question/Challenge about my upcoming project, I'm about to move onto my second project, and I'm considering using a V2000 as a base unit, shown here: Another blokes used one here, And I've currently also got a water cooling system I have to fit in. Thing is I've got 2 single heatercores, from soulsend, shown here: The shroud itself is 6"x6"x2" and the heatercore 7 1/2”x6”x 2”. They seem to be approximately 16cm x 18cm x 10cm, but that's a guess from very rough measuring. Now, the question is, how do I fit these babies in.... I was thinking of say moving the PSU to the up a bit, so it's where the radiator is on the above guy's setup, and then having the heatercore on its side below, so it blows right to left, but I'm not sure that'll work. Anyone have any ideas? I'm stumped.