Quote:
|
Originally Posted by JFettig
wait up, you cant just pop them into the machine like that, especially with the feeds that high 
30,40,80IPM are most likely 5x too high, I didnt really look at the code too much, Ill open it in a better viewer. but still, you need something for the machine, you would probably be best off bringing a drawing to a machinist running the mill, either that or tell us what mill it is and stuff.
Jon |
Yes, he can...as I've said the code is not OK, it needs modifications, all I want to know is whether the machine is capable to accept G-code like this one or not...if it does, a simulation could be run without any problems. I did not tell him to try to MACHINE the part with this code.
BTW, a code very similar was used for machining of a few blocks...picture attached.