I was just about to direct a question at you pHaestus. It was going to be
"Does the 00 inlet tube have a tapered nozzle design just like the 02's tube (but obviously coming to a finer point)?"
Quote:
|
Personally I wonder how well that the MCW6002 would do if it had an inlet nozzle that tapered to closer to 1/4" ID and but still used 1/2" barbs.
|
Maybe someone who owns the block (I dont) could make a sort of nozzle insert doing just that. And test it.
As for the personal matter, I dont (much) care about tidiness, but rather about torque on the block's mounting. Im sure I can get around it, but I 've never held an MCW6k in my hand nevertheless seen one in person so IDK.
Does anyone think that the three prong clip may help in reducing torque due to tubing bend and wheight of 1/2 ID?
SenC.