if you have threaded ends they are 3/4" NPT male
ck mcmaster copper fittings and adaptors
- upsize the 3/4" male end to a 1" spigot, put that into the branch of a 3x3x1 (reducing branch) tee set veritcally, and put a cap/plug on the bottom
- put a 2" length (net) 3" tube in the top of the tee on the inlet, and another 3x3x1 reducing tee wit the branch pointed in the direction that the inlet tubing will be coming from; put a threaded reducing bushing in the 1" branch
- sealed or vented ?
adapt to fit
note that the res for this pump should be 4" dia, 3" is minimal (velocity too high)
copper preferred for this app
|