Quote:
|
Originally Posted by Chew_Toy
I am personally looking forward to this. I am considering building a system with 5/16 ID tubing with a c-systems pump or an mcp600 with probably the Alphacool HP cpu block. I am hoping for temps within 2~4° of my 1/2 setup. But I honestly dont see a system based on 6mm tubes being within 1° of the 1/2 system. I believe that a 10mm ID system can get basicly the same results nowdays with the higher head pumps and more restrictive blocks but untill its proved to me I dont see it with the 6mm ID stuff.
|
I think you may be pleasently surprised but as they say the proof is in the pudding.
On a side note and possibly another advantage.
I currently cool a CPU. GPU, Northbridge, Hardrive and moffsets using an old 1048 pump and 8/6mm tubing. When I added the hardrive and moffsets it had no effect on my CPU temps.