Pro/Forums - View Single Post

Pooky · 07-28-2004, 05:15 PM

Hi, I've never posted here, and I'm not sure if this is the proper place for this, if not, just move me/it.

In the Innovatek Rev 3 block review, when you (pH) claimed that the block had been moddified to fit 1/2" barbs, did that mean that the 1/4" threads were bored out to 1/2"? If I was looking at that Innovatek block and had a similar setup to your test setup, would I be looking at similar results if I was to use 1/4" threaded to 1/2" (or possibly 3/8") barbs? If I need to bore the threads out, what sort of cost am I looking at?

Thanks

07-28-2004, 05:15 PM	#1
Pooky Cooling Neophyte Join Date: Mar 2004 Location: Oregon (soon) Posts: 12	Innovatek Rev 3 Block Help/Info Hi, I've never posted here, and I'm not sure if this is the proper place for this, if not, just move me/it. In the Innovatek Rev 3 block review, when you (pH) claimed that the block had been moddified to fit 1/2" barbs, did that mean that the 1/4" threads were bored out to 1/2"? If I was looking at that Innovatek block and had a similar setup to your test setup, would I be looking at similar results if I was to use 1/4" threaded to 1/2" (or possibly 3/8") barbs? If I need to bore the threads out, what sort of cost am I looking at? Thanks