So, now we finally made our first serious wb. Just one problem.. it performs really poor (like a maze 3)..
I have a few ideas to what the problems might be.. but would like to hear your opinions about it..
The water from the inlet is probably not reaching the bottom.. i'm thinking of trying to use a 12mm copper pipe, allowing water only to get out 2-3mm above the bottom..
We made the bottom 3 mm thick, except in the middle where we went down to 1 mm. I guess that is a bit to thin for this design especially if the water isn't getting down there.. :shrug:
The area with "fins" is about 20 mm, perhaps it needs to be expanded to lets say 30 mm?
Any ideas or suggestions are welcome, before we head back to the workshop again..
Sorry about my poor spelling and grammar.. it's late and i had to drink a lot of beer to wash down some dissapointment
