Pro/Forums - View Single Post

2Busy · 08-02-2004, 03:41 AM

When I fist started reading about wc my rig, I would have thought flow ( say volume) would have been much more important than pressure. Now I am not so sure. Maybe I am misundestanding all that I am reading. The impingement is based more on higher pressures than higher flows correct? If this is correct, then a block like the Swifty MC6000 should benefit with a pump with a higher achievable head pressure, yes? The cooling setup I am considering would be with the MC6002A with either the Swiftech pump or Danner Mag 3 with a large rad that excepts 2 120mm fans to put in the top of my full tower. All feedback is greatly appreciated. This site rocks more than any other for tech discssions on wc.

08-02-2004, 03:41 AM	#1
2Busy Cooling Neophyte Join Date: Jul 2004 Location: Oklahoma Posts: 62	Let me see if I understand this .... When I fist started reading about wc my rig, I would have thought flow ( say volume) would have been much more important than pressure. Now I am not so sure. Maybe I am misundestanding all that I am reading. The impingement is based more on higher pressures than higher flows correct? If this is correct, then a block like the Swifty MC6000 should benefit with a pump with a higher achievable head pressure, yes? The cooling setup I am considering would be with the MC6002A with either the Swiftech pump or Danner Mag 3 with a large rad that excepts 2 120mm fans to put in the top of my full tower. All feedback is greatly appreciated. This site rocks more than any other for tech discssions on wc.