Pro/Forums - View Single Post - Quick Fedco 2-342 Question

babybunny · 08-22-2004, 07:18 PM

I was looking at a chart on the Fedco 2-342 and it said that "the 0.75 inch intake end is actually 0.625 inch @ radiator." Does this mean that this end starts at 0.75 inch and actually narrows down to 0.625? After I dremel it down to the narrow end is there still going to be enough room to heat up some tubing and stretch it over the remaining fitting?

One last question: What tubing heats up well? I like vinyl because it's cheap but I don't like how it's so kink prone.

08-22-2004, 07:18 PM	#1
babybunny Cooling Savant Join Date: Jun 2002 Location: USA - Ohio Posts: 120	Quick Fedco 2-342 Question I was looking at a chart on the Fedco 2-342 and it said that "the 0.75 inch intake end is actually 0.625 inch @ radiator." Does this mean that this end starts at 0.75 inch and actually narrows down to 0.625? After I dremel it down to the narrow end is there still going to be enough room to heat up some tubing and stretch it over the remaining fitting? One last question: What tubing heats up well? I like vinyl because it's cheap but I don't like how it's so kink prone.