Quote:
|
Originally Posted by Lothar5150
I have a dual xeon rig. I highly recommend you use a HC and ditch the BIX.
|
Have you recorded your ambient temp, water temp, die temp, all at load and idle?
Pretty much the only way to see if anything is actually wrong...
If your water temp is really high above ambient (say ambient 25c and your water temp 30+, on a good setup you wont have more than 1-3c dif) then make sure there are not kinks, your pump isnt over loaded or dying and you are getting good air flow through your rad and you have a big enough rad.
If your water temps are good and die temps really high make sure you mounted the blocks well and you have no bubbles in your lines.