View Single Post
Unread 09-10-2004, 07:11 PM   #1
jwill
Cooling Neophyte
 
Join Date: Jul 2003
Location: vancouver, washington
Posts: 14
Default FS: My Main Rig... *Pics Posted*

Main Rig...

Hardware:
• AMD Athlon XP-M 2600+
• DFI Infinity nForce2
• 3x 256MB Mushkin Level 2 BH-5
• ATi 9800 Pro 128mb
• Antec TrueControl 550w
• Seagate Barracuda ATA IV 80gb 7200rpm
• TDK Internal E-IDE CD-RW 48/16/48
• Coolermaster Wavemaster Case
• Logitech Cordless MX Duo

Cooling:
• VGA: Arctic Cooling VGA Silencer Rev. 3 & OCZ Copper BGA Sinks
• CPU: Zalman CNPS7000A-Cu
• MB: Swiftech MCX159

OCs:
• CPU does 2625 at 250x10.5 at 1.95v.
• Motherboard does 250 FSB at 1.80v.
• Memory does 250 at 2-2-2-5 with 3.3v.
• Video does 420/380 at stock volts.

• CPU temps taken with Winbond's Hardware Doctor. Never went above 50c during load.

• 3dmark2001 benched at 250x10=2500mhz with 1.90v and 9800 Pro at 420/380...
21089 - http://service.futuremark.com/compare?2k1=8071295

• Super_PI bench... http://home.comcast.net/~jwill83/super_pi_36s.jpg

Posted at the "Super-PI Challenge!" on the bit-tech forum (11th down)...
http://forums.bit-tech.net/showthread.php?t=39994

Mods:
• Goal was for Clean and Quiet.
• Full Cable Sleeving.
• Super Clean Cable Managment.
• 2x UV Clear Round 10" Single E-IDE Cables.
• 2x 120mm Aluminum Case Fans added to top and bottom of case.
• 1x 80mm Aluminum Case Fan to replace stock back exhaust fan.
• 3x Front Mounted Switches to control the three aluminum case fans. Three settings 12v, 5v and off. The third switch is a little loose.
• TDK CD-RW Bezel replaced with stock blank cover.
• Window cut for CD-RW when in an acrylic case but never added actual window after wavemaster purchase. Anti-static bag taped over window to cover from dust.
• 2x Stock front fans removed after 120mm case fan improvement.
• Arctic Cooling VGA Silencer Power Cable modded to 4-pin molex connector to run directly off the power supply instead of the video card.
• Matching Tall Case Feet to improvent air supply to lower case fan.
• Zalman Fan Controller Double-Sided Foam Taped to motherboard surface.
• Chrome Door Molding surrounding cuts made for the 120mm fan improvement.
• Fans mounted with Fan Isolators (execpt the top), eight extra included.
• Hard Drive Suspended with Stretch Magic Elastic Cord for tight well secured vibration dampening.
• Antec Power Supply Control Panel removed from bay mounting and mounted to the inside chassis (out of sight) since the control panel bay mounting didnt match well with the case.
• Air Duct Cut into Coolermaster Side Door for Zalman CPU Cooler fresh air intake.

$1050 Shipped

• Manuals, Documents and cables needed are included.

• Weighing in at just over 30 pounds.

• Pics...

http://home.comcast.net/~jwill83/P1010002.JPG

http://home.comcast.net/~jwill83/P1010007.JPG

http://home.comcast.net/~jwill83/P1010006.JPG

________

Logitech Z-680 5.1 Surround Sound Speakers...

• A few scratches on the controller, nothing major.

Sold.

________

Microsoft XBox Package...

• Xbox Console (w/ Video and Power Cable)
• Xbox Live Starter Kit (w/ Headset and Software)
• Xbox Action Replay Kit (w/ Memory Card, USB Interface, Software and Manual)
• Two Original Xbox Remotes.
• MotoGP 2 (Online Enabled)
• Unreal Championship (Online Enabled)

$150 Shipped

________
________

• Money Order / Cashiers Check prefered method of payment.

• Shipping Priced are within the USA.

• Guaranteed non-doa.

jwill83 (a t) comcast (d o t) net

• AIM: jwill1337, Y!: jwill_1337

• heatware id = jwill

• PM me for more contact information if you need it.

• Thanks for looking.

Last edited by jwill; 09-26-2004 at 06:33 PM.
jwill is offline   Reply With Quote