Pro/Forums - View Single Post - 7/16" ID (5/8" OD) tubing - ultimate size cross-over?

gungeek · 09-14-2004, 11:45 AM

How hard was it to install the 7/16ID tubing over 1/2 OD barbs? This sounds like a good idea.

I've tried installing 3/8ID (1/2OD) tubing over 1/2OD barbs and that didn't work at all; the tubing wall wasn't thick enough to push it over the barb after being heated with hot water.

09-14-2004, 11:45 AM	#5
gungeek Cooling Neophyte Join Date: Aug 2004 Location: Oklahoma, USA Posts: 17	How hard was it to install the 7/16ID tubing over 1/2 OD barbs? This sounds like a good idea. I've tried installing 3/8ID (1/2OD) tubing over 1/2OD barbs and that didn't work at all; the tubing wall wasn't thick enough to push it over the barb after being heated with hot water. Last edited by gungeek; 09-15-2004 at 11:36 AM.