Pro/Forums - View Single Post

DoughtCom · 09-29-2004, 12:32 PM

I'm building a bong cooler setup, that will be 3 feet 3 inches tall. I want to run the water through 1 black ice micro II radiator before it gets there, after passing through my Swiftech MCW6000-A CPU water block and a Swiftech MCW50-T peltier GPU cooler/waterblock and then back through a peltier watercooler creation that will have low resistance. The 1/2" tubing from my case to that will be about 2 feet there and 2 feet back.

Was wondering if I got a eheim 1250 if that would be enough flow for this setup.
And if I were to get a 1260 if that would cause too much PSI for the tubes/clamps to handle.

If anyone could help that would be awesome.

Thanks!
Shawn (DoughtCom)

09-29-2004, 12:32 PM	#1
DoughtCom Cooling Neophyte Join Date: Sep 2004 Location: Edina, MN Posts: 5	What type of pump for this setup. I'm building a bong cooler setup, that will be 3 feet 3 inches tall. I want to run the water through 1 black ice micro II radiator before it gets there, after passing through my Swiftech MCW6000-A CPU water block and a Swiftech MCW50-T peltier GPU cooler/waterblock and then back through a peltier watercooler creation that will have low resistance. The 1/2" tubing from my case to that will be about 2 feet there and 2 feet back. Was wondering if I got a eheim 1250 if that would be enough flow for this setup. And if I were to get a 1260 if that would cause too much PSI for the tubes/clamps to handle. If anyone could help that would be awesome. Thanks! Shawn (DoughtCom)