Quote:
|
Originally Posted by Cathar
I live in Australia. I work with the hand I'm dealt with. Right now the entire country is out of the barbs that I used on the block as it is. O-ring seal barbs like DTek use are non-existent here, or at least none of the supply places have them just sitting around. Can special order them in, but not cheaply in any fashion.
These are the joys of living in a nation with a small population base that also does not make a large portion of US consumed products.
|
hmm, do your engineers have a CNC lathe? Ive personally designed and machined up fittings on a CNC lathe; its pretty quick, especially compared to a block. Shouldnt cost too much a fitting - might even get close to the price you pay for the ones you're using now, if you do a long enough run (ie, 100+, which i imagine you will...)