Ummm, O.K.
Whats the waterflow going to be?
This is a serpintine radiator, or is it going to be a tanked thin tube multipass unit like a heatercore.
Serpintine ASCII example, the = are the barbs.
input
=----------\
/-----------/
\-----------\
/-----------/
\----------= output
Parallel ASCII example
|#|==========|#|= input
|#|==========|#|
|#|==========|--| flow seperator
|#|==========|#|
|#|==========|#|= output
the |#| is the tank. A multipass radiator uses multiple think tubes to increase the surface area, while retaing the flow rate.
Yor picture looks like it's tanked, but I don't understand how you are going to force the flow thru the tubes.
Also, have you ever soldered a heatercore or radiator before? I once cut a heatercore down so a 120MM find would fit it perfectly (in fact I still use it) , as I was dealing with a very tight fit. soldering that thing back together was a [expletive deleted].
Paul.
|