Cracked pump
Yesterday while trying to tighten a connection down just a "little bit more" on my pump, I cracked the casing. It's a MagDrive 250 and I cracked the female port just straight down the side about a half inch.
Now this was right as I was gooping up all of my connections on the pump. I figured, that since the crack wasn't too big, if I could just goop it up enough it would be ok.
I was just curious if you guys think that the pressure inside or anything else might bust through the goop? I put a good bit on there and will probably tape it too.
Thanks,
Jason
|