advice on a new waterblock..
OK, i am currently looking to purchase a new water block to replace my swiftech 5002-p.my system specs are as follows:
p4 2.53@2.86 ghz
swifty 5002 WB half inch i.d
danner mag 5 pump
Ford heatercore (dunno from what vehichle) 7x7.5x2
2 120mm fans in a pull config attached to a shroud
2 resivoirs (danners leak after a 2 months i find, i dunno why)
the block i want is 1 that i will be able to use on a 754/939 or a 478 platform. i'm not quite ready to replace my 875 mobo atm. as far as temps go, i usually run aat 34-35c at idle, and about 38-39c at load. Any sugestions will be appreciated..
TY
|