Here is an update on where I'm currently at...
As for my setup, I think I came up with a compromise. Sub-Zero and Sub-Ambient temps are out. I decided to purchase a third YY cube to house the cooling system for both computers which will consist of 2 loops (1 per PC) with an MCP650 Swifty blocks and 2 Thermochill 120.2 Rads (1 per loop) connected to a single 1 gal Res which will have an aquarium IceProbe in it.
The third case with the cooling system will also have its own power supply for the pumps, chiller, and rad fans. I came up with a wiring scheme using some relays and diodes to allow the thrid PS to be turned on by either one of the main PSUs, it also applies power to each loop independantly, so if only 1 of the computers is on only it's w/c loop will have flow.
Construction will start in the next week or so. I'm a bit of a perfectionist, so it will most likely be awhile before the project is complete, but I will keep you guys updated with pics of my progress throughout the build.
Oh, one last asthetic question... Since all 3 YY cubes will have windows in the side, should I paint the inside of the cases, or leave them bare metal???
Bill
Note: I attached an image of the w/c systems design for you guys...
|