Right now I am using MBM to monitor temps with it set to shutdown the PC if they get too high. Of course the real problem with this is it is using the winbond measurements which are not very accurate. I also thought that by monitoring via a combination of flow rate and water temp you would get some more options (maybe warning messages for decreases in flow). Plus I really don't want to have to wait for the temps to start rising before the computer starts shutting down (especially if there is a big problem like a dead pump), if the flow rate decreases below a certain level then start shutting down even if the temps havn't gone up yet.
This is all just food for thought though, until someone who can actually design a working circuit for it comes along then maybe I could actually build and test it!!!
Bill
|