Quote:
Originally posted by Brad
remove the mounting tabs and use AS epoxy then, that will work just fine.
Yeah, you would hit the channels, but it wouldn't be hard to modify that on a block, I am sure that DDen might think of this in a later version
|
You can't put and bolts around the core of the CPU. If you modify the channel you loose your flow rate. The only place to put a bolt hole is in the middle area of the block(which is the only place it would make sense to put a hole because you can't put it through the Pelts) and it can't be anywhere near the center because that is where the core is. So the only other place is 2 holes in the middle on the outside corners. Right where my channel is.The only way to do that is to leave a 1/4" chunk left in the channels to make a hole with threads. Thats not going to happen as that is just like cutting your 1/2" hose in the middle and putting in a 1/4" splice peice in. Would defeat the purpose.
Also I will not make a block to where a customer has to modify his mobo in any way to make it fit. To many liabilities. Not to sure why any one would put morethan one pelt on anyway? You will loose most of the extra cold off to the sides of the core and just cause more condensation.