It is infact the exact same car, as in the article yes.... just not Black any more....
In order, stripped from the outside....
Looking at the front endplate of the blowers gearhousing(yellow),
with the shaft in green,
the bolts in white ,
the additional bearing is red
and it's housing is pink.
this last one give an idea of how nice and snug this blower will fit.... less than 60mm to the fan-belt plane.... the extra bearing is not really needed, but I'm putting one in, while I'm at it....
the intake is going to be very simple, actually, a flange, looking like the green one... the white one is the exhaust flange.
now just construct plenums from the 3 round black holes, down to the ports..
this flange is also going to be responsible for holding the blower in place, I might think about adding a support strut on the opposing side, just to do a good job...