Pro/Forums - View Single Post - Danner Mag 3 disassembly & sealing info and impeller/magnet direct coupling attempt

the jew (raven) · 11-14-2004, 02:05 AM

What fittings are you guys using on your Mag 3? I've heard that just getting a 1/2" NPT to 1/2 OD barb is too restricitve for the pump. So if you're not supposed to use those fittings, what would one use? I'm using 1/2" ID tubing (obviously).

EDIT:

I pressuming the answer of female 1/2 - 5/8 barb (outlet) and a male 1/2 3/4 od from this thread is still true?

http://forums.procooling.com/vbb/sho...light=mag+pump

11-14-2004, 02:05 AM	#16
the jew (raven) Cooling Neophyte Join Date: Nov 2003 Location: Where hockey pucks fly free Posts: 12	What fittings are you guys using on your Mag 3? I've heard that just getting a 1/2" NPT to 1/2 OD barb is too restricitve for the pump. So if you're not supposed to use those fittings, what would one use? I'm using 1/2" ID tubing (obviously). EDIT: I pressuming the answer of female 1/2 - 5/8 barb (outlet) and a male 1/2 3/4 od from this thread is still true? http://forums.procooling.com/vbb/sho...light=mag+pump Last edited by the jew (raven); 11-14-2004 at 02:33 AM. Reason: I searched a bit more......lo and behold the answer was there