View Single Post
Unread 11-28-2004, 02:32 PM   #18
Output
Cooling Neophyte
 
Output's Avatar
 
Join Date: Oct 2001
Location: Sweden
Posts: 31
Default

Just got the block and wow, is it small!

Did open it and it looks like its not just the jets and the "jet target" area that cause the high resistance. The chamber where the jets are looks so small, and there are sharp edges in the inlet to the chamber. Also where the dimpled jet target area lets the water out is soo tiny, and the outlet contains sharp edges.
I think that this block can easily be modified so that the edges are smooth, the jet chamger lets water flow better, also the the outlet can be modified easily. Since its nickled copper, I guess its possible to do it?

I was thinking of cutting in the top to make the inlet jet chamber bigger and smoother. Also cutting in the middle plate so that the outlet is smooth and that the water that came out of the jet target area can escape easier. What do you think?
__________________
parallel rads is the only way to go!
Output is offline   Reply With Quote