Pro/Forums - View Single Post - What do you want to see in a Water Block???

jaydee · 01-03-2002, 03:30 PM

I see!!!

Well I just got a block of Copper to work with and it was sheer torchure on my Mill but I got a Copper block Milled out now. I am going to have to rework the CNC code to make it easier on the mill.

The rest of my stock should be here Friday. I will post pics of the copper block on my website and i will be testing it that same way I did with the Aluminum one to see what different temps I can get between the two blocks.

I think I may have found a flaw in my last testing aswell. There was to much airflow around the back of the motherboard which may have caused lower temps. I will retest each block better this time.

01-03-2002, 03:30 PM	#66
jaydee Put up or Shut Up Join Date: Dec 2001 Location: Spokane WA Posts: 6,506	I see!!! Well I just got a block of Copper to work with and it was sheer torchure on my Mill but I got a Copper block Milled out now. I am going to have to rework the CNC code to make it easier on the mill. The rest of my stock should be here Friday. I will post pics of the copper block on my website and i will be testing it that same way I did with the Aluminum one to see what different temps I can get between the two blocks. I think I may have found a flaw in my last testing aswell. There was to much airflow around the back of the motherboard which may have caused lower temps. I will retest each block better this time.