no 'claim' to thread,
my only concern is that everything becomes so scrambled
Les
my whole problem with the modeling bit, is one to conclude that the measured watts are hugely low ? or temperature compression ? some of both ?
- or that the model is disconnected ?
why I test
a disclaimer, conditions
#1 all data is preliminary, the procedure is still being defined (Roscal note, those curves will be re-stated)
#2 consider this rad data as a unique data set;
in terms of control, accuracy and repeatability it is considerably better than the 2 previous efforts
#3 rads connected in a uniform manner, laid flat, fan(s) pushing w/grille guard(s)
#4 fan intake positioned 3" below the horizontal discharge of the environmental chamber's air conditioning
#5 fan discharge isolated from intake with a 4" horizontal baffle at the rad discharge face (the rad body is exposed to the 'cool' intake air)
readers interested in rad test data need to read and consider this post
http://forums.procooling.com/vbb/showthread.php?t=11039
here is one so curious that I ran some addl points to confirm

this curve will shift when I re-do, the tail will rise, but even so