Ok as says in name i'm going back to watercooling...
This is the Gear
http://forums.bit-tech.net/showthread.php?t=80560http://forums.bit-tech.net/showthread.php?t=80560
2 X Tank-o-Matic's
1 X kit Kat
2 X Green dye's
1 X power fluid
1 X 1250 pump
1 X nv68
1 X Sliver TDX <<
1 X Pci relay card
1 X Artic Silver
1 X T shirt
1 X Tygon Pipe
I would like to thank paul again:P. lol, also someone called "sparks"

.
Also like to thank acrim, you will find out later.
I am modding my YY cube...
This is going to be the WC setup..
If you can make sence of that is the led setup..
I am having two led's each side of res (2 of each res) they are going to be uv,
but i am having 3 in the middle that are different LED colours. But these led's will be controled in software, I am going to put it into a printer port, to allow me to turn the led's on and off, the uv led's on and off, and to be able to do effects. Also I will be able to access the led's online,

So i can turn them on and off anywhere

.
Starting to get the case ready.
First hole Cut
YAY 2nd hole cut.
Right time to cut the res holes