Thread: GF6800 cooling
View Single Post
Unread 01-25-2005, 06:32 AM   #11
Butcher
Thermophile
 
Join Date: May 2001
Location: UK
Posts: 1,064
Default

Been thinking about this some more.
Had some thoughts of modding the DD block by attaching (either solder or epoxy) a brass/copper block over where the barbs are which I can use to effectively make a right anglebend in the outlets with. I can then drill + tap the ends of that and refit the DD barbs.
Comments?
__________________
Once upon a time, in a land far far away...
Butcher is offline   Reply With Quote