My loop make up was a quick 5min job.
The setup is going to be:
pump - rad - tdx - nv64 - res -res - pump
Ok Hi all,
Been about 9days, the project log hasnt been dumped. I been busy, well TBH!! Lazy.
Anyway, the led circuit is going well thanks to matt(acrim)
I spent well, a good week getting the screws in this rad. And finally done it, it doesnt look much, but trust me it was a 100% pest. When pauls it, he is gonna have to buy my a pint for it
.
LOOK AT THAT. Lovely sexyness looks so so so NICE!.
Holes big enough for tube to go through
...
Bigger hole for tube to go though .
Today I cut the hole little bigger for res (again). So it's all ready now to be screwed in, with the leds etc.
Anyway I cut holes for pump today. Very tight on one of the screws and the wheel.
BLeh as you can see, I put vibration mount in, there is about 0.02mm of a gap for the nut :X!
Next thing, is I cut the front of the case pannel today. It had a big plastic block that would really suck for the air flow. As the fans are sucking the air will be sucked in from the bottom, goes up though the 2 X fans and out. So I have to cut this plastic bit out for air flow:
- Update for today.
And yes I will tidy up the hole:P. It doesnt "really" matter as it wont be viewable at all
- S