Quote:
|
Originally Posted by KuniD
Unfortunately no overclocking There's very few Opteron motherboards that allow for it, and I doubt the Iwill will have any. I want to watercool both Opterons to keep the noise at a bare minimum, while also keeping them as cool as possible; if the cooling system is quite robust it'll be able to handle dual core Opterons which I'm looking to drop into the box Q1 06.
But I will be overclocking the hell out of which ever SLI setup I go for Maybe even TEC's
|
If you end up on TECs the a GPU block only solution might be more effective than the block'n'ram options. The ram cooling is really something at the margins and may detract from the GPU cooling performance ( as well as making it impossible to mount a pell, come to think of it!). If you're relly hitting the card hard and want something for the ran though you could do a seperate mini-loop with
these babies.
Quote:
|
While I've used 1/2" in the past I think I'm going to stick with 3/8" for this system; with the blocks, rads and pumps I'm choosing it shouldn't be a problem.
|
Righto, If it helps Asetek sell kit with pushfits for 1/2" OD 3/8"ID, same as swiftek, however its not available in every reseller in europe.
Quote:
|
I don't think thats possible; as the motherboard is housed in the upper compartment the upper edge of the mobo is right at the top of the case, less than an inch from the roof.
|
You're right. I was remembering the V1000 that strangely has a little more room there.
Quote:
|
As I have to wait a little bit more before I can get the parts I want, I've had another look into whats going to be available, and around March time retailers should have the LSI Logic SATA 300-8Xfor sale, which is a hardware SATAII-RAID controller. Being SATAII, it'll allow me to expand using port multipliers, so I may need to re-think the location of that dual 120 at some point in the future, if I ever want to expand with more drives.
|
Nice card, makes my 2410SA look a bit limp
